Pure Water Jet Cutting

For Pure Water Jet Cutting, the water jet, which is generated in a diamond nozzle, forms the separating tool and its erosive effect alone is used to remove the material. Because the cutting power for hard material is very limited, this procedure is used especially for soft materials.

The advantage of Pure Water Jet Cutting is high precision.
This allows the manufacture of complex shapes and geometries with the finest contours, sharp angles and tight radius.

Capacity:

  • MULTIPLE CUTTING HEADS
  • 6000lb Max work piece weight

Tolerances:

  • +/-.005” on Most Thin Materials
  • +/-.010” on Most Thicker Materials

 

Efficiency

  • Cutting Head Equipped with ITC. The Waterjet ITC system analyzes cuts and provides taper control without the need for reducing speed by inclinating the high-pressure waterjet up to 2° while maintaining stream velocity. The result is a final part that is produced faster and with straighter walls, regardless of the thickness or composition of the material being cut

Quality

  • Clean dross free edges with a sandblasted finish
  • Minimal mechanical stresses are applied to the material
  • No heat affected zone is created
  • Better finish and accuracy than laser cutting in materials over 12mm thick
  • High levels of accuracy and repeatability

ACP Waterjet Specializes in Water jet Cutting - Pure Waterjet | Abrasive Waterjet Cutting | Water Cutting | Water jet Cutting Companies | Waterjet Shim Stock | Waterjet G10 | Waterjet Composites | Precision Water jet Cutting of Aluminum, Copper, Hastelloy, Plastic, Lexsan & more for New England, Cape Cod, Massachusetts, New York, Pennsylvania, Rhode Island, Connecticut, South Shore, Western Mass, Eastern Ma and outlining areas.