Waterjet Cutting
Waterjet cutting uses a high pressure stream to cut without creating a heat affected zone. Abrasive waterjet is used for most metals, plastics, and composites. Pure water cutting may be used for selected foams and rubbers.
| Specification | Value |
|---|---|
| Maximum standard part size | 58" × 118" |
| Minimum standard part size | 1" × 1" |
| Maximum Instant Quote thickness | 1.000" |
| Minimum inside corner radius | 0.030" |
| Common materials | Metals, Lexan, plastics, composites, rubber, and foam |
| Heat affected zone | None |
Process characteristics
- The cutting stream is round and is typically about 0.030" to 0.042" in diameter. A sharp internal 90 degree corner cannot be produced without a radius or relief.
- ACP uses 0.030" as the standard minimum inside corner radius for Instant Quote parts up to 1.000" thick.
- ACP’s taper control head can typically hold edge taper to about 0.002" under standard conditions. Results depend on material, thickness, geometry, and cut quality.
- Abrasive may be embedded or remain on some surfaces and internal features. Clean critical surfaces when required.
Need something outside the standard? An ACP estimator will review your complete requirements and confirm the right manufacturing method.
Request a Custom Quote